All prices include tax.

The Ultimate Guide to Perfectly Installing Your High Simulation LED Tree

The Ultimate Guide to Perfectly Installing Your High Simulation LED Tree

How to Install an LED Tree

            Installation steps:

  1. Open the package, check all the parts. Ensure that it is placed on level ground. Position the tree trunk in your desired location. Use the bolts to secure position if installing outside.
  2. The trunk comes in red numbered sections which need matching. Connect the male and female electrical connectors. Screw the protective cap over the connectors to ensure a watertight seal.
  3. Push the connected wires into the base making sure the wire is not pinched or caught and slot into place.
  4. Using the large hexagon key secure the trunk with the grup screw.
  5. Next match the corresponding numbers on the main brunches to the trunk. Connect using the male and female sockets, then screw the protective cap over the connectors to ensure a watertight seal.
  6. Fix the branches in place using the small hexagon key, ajust the flower branch to create a fuller shape.
  7. Once the branches installed, check if all screws and connectors are perfectly fixed, then connect the plug into the socket, turn on the power.

Note: Not allowed to connect the wrong woltage or operate on live line.

 

INSTALLATION INSTRUCTIONS. HIGH SIMULATION LED TREE

Older Post
Newer Post

Leave a comment

Please note, comments must be approved before they are published

Close (esc)
Popup

Use this popup to embed a mailing list sign up form. Alternatively use it as a simple call to action with a link to a product or a page.

Age verification

By clicking enter you are verifying that you are old enough to consume alcohol.

Search

Shopping Cart

Your cart is currently empty.
Shop now